Campbell Hausfeld CE7000 Serie Instructions D'utilisation page 19

Troubleshooting Guide for Units in Service for a Period of Time (Continued)
SyMpToM
Oil in discharge air
CAuSe
Restricted intake filter
Wrong type of oil
Worn rings or scored cylinder Replace rings and/or replace cylinder�
Compressor running hot
Series CE7000, CE8000 and CE9000
SoluTion
The filter should be changed frequently to avoid possible problems and
to make the compressor operation efficient� There is a vacuum created
in the intake of the compressor, which causes high oil consumption by
pulling oil through the rings� There is also a chance of the intake filter
media being destroyed, allowing contaminants to enter the intake and
cause wear problems�
Do not use SAE-30 automotive type oil. Using the wrong oil can cause
various problems with the pump and will void the warranty� Only use
the oils that the operating manual recommends�
Make sure compressor is running the correct rotation� Compressor
should be clean and in a well ventilated area� Oil should be changed on
regular intervals according to the specifications listed in the manual�
Air filter must be changed as it gets dirty�
www.CH-Commercial.com 19