Operating Your Spa; 6205 Electronic Control Operation; Switching Modes - CalSpas Aqua SQ63 Guide D'utilisation

Operating Your Spa

Operating Your Spa
6205 Electronic Control
Operation
Initial Start up
When first powered up, it will automatically
revert to Priming mode. A Pr on the topside
display will indicate this. Priming mode
will be active for less than five minutes at
which time the heater will be activated and
the water temperature will be maintained
in Standard mode. The spa will heat to
37°C at start up until the set temperature is changed as
described below.
Temperature Adjustment
(Range 26°C to 40°C)
The 6205 electronic control panels display the actual
water temperature in degrees Fahrenheit. The
displayed temperature will only be current after the
pump has been running for at least 2 minutes.
To display the temperature that the spa is set to:
• Press the Temp button. The temperature setting
will flash.
• While the display is flashing, each time you press
Temp button, the set temperature will change up or
down one degree.
• If the desired temperature is opposite of the
direction each press of the button is making,
release button, allow display to stop flashing and
then press Temp button to change temperature the
other direction.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
• St will light briefly on the main display. In this
mode, the heating system will automatically
maintain the set spa temperature. In the economy-
heating mode, the heating system will only activate
during filtration times.
• Ec will display solid if temperature is not current
and will alternate with spa temperature if measured
temperature is current.
• Economy mode will heat the water to the set
temperature while Sleep mode, indicated by a
SL on the main display, will also only activate the
heater during the filtering cycles but will only heat
the water to within 10°C of the set temperature.
Page 8
Like Economy mode, SL will display solid when
temperature is not current and will alternate with
actual temperature when it is current.
NOTE: Displayed temperature will only be current after
the pump has been running for at least 2 minutes.

Switching Modes

• Press Temp button followed by the Light button.
• Press the same sequence to switch to the next
mode.
Jets
Press the Jets button:
• Once to activate low speed pump.
• Twice to activate high speed.
• Three times to return to turn pump off.
Light
Press the Light button to turn on the light. Press it
once again to turn the light off. All optional lighting such
as the control panel light and cabinet perimeter lighting
is controlled by the Light button and will turn on and off
with the spa light.
Option
Press the Option button to turn on the pump 2 on.
Press it once again to turn off the pump 2 off.
Automatic Time outs
These features will automatically turn themselves off
during periods of continuous use:
• Low speed pump
• High speed pumps
• Optional circulation pump
2007 Portable Spa Owner's Manual
After 4 hours
After 15 minutes
After 15 minutes
LTR20071001, Rev. B