sunjoe 24V-X2-CS16 Manuel D'utilisation page 5

Masquer les pouces Voir aussi pour 24V-X2-CS16:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Place the battery packs in storage only after they have
been fully charged.
8. Protect batteries and the tool from overloads. Overloads
will quickly result in overheating and cell damage inside
the battery housing even if this overheating is not
apparent externally.
9. Avoid damage and shocks. Immediately replace batteries
that have been dropped from a height of more than one
meter or those that have been exposed to violent shocks,
even if the housing of the battery pack appears to be
undamaged. The battery cells inside the battery may have
suffered serious damage. In such instances, please read
the waste disposal information for proper battery disposal.
10. If the battery packs suffer overloading and overheating,
the integrated protective cutoff will switch off the
equipment for safety reasons.
IMPORTANT! Do not press the ON/OFF switch any more
if the protective cut-off has been activated. This may
damage to the battery packs.
11. Use only original battery packs. The use of other batteries
poses a fire risk and may result in injuries or an explosion.
Information about the charger and the
charging process
1. Please check the data marked on the rating plate of the
battery charger. Be sure to connect the battery charger
to a power supply with the voltage marked on the rating
plate. Never connect it to a different mains voltage.
2. Protect the battery charger and its cord from damage.
Keep the charger and its cord away from heat, oil and
sharp edges. Have damaged cords repaired without delay
by a qualified technician at an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
3. Electrical plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
grounded appliances. Unmodified plugs and matching
outlets will reduce the risk of electric shock.
4. Keep the battery charger, battery packs and the cordless
tool out of the reach of children.
5. Do not use the supplied battery charger to charge other
cordless tools.
6. During periods of heavy use, the battery packs will
become warm. Allow the battery packs to cool to
room temperature before connecting it to the charger
to recharge.
7. Do not overcharge batteries. Do not exceed the maximum
charging times. These charging times only apply to
discharged batteries. Frequent insertion of a charged or
partially charged battery pack will result in overcharging
and cell damage. Do not leave batteries in the charger for
days on end.
8. Never use or charge batteries if you suspect that it has
been more than 12 months since the last time they were
charged. There is a high probability that the battery
9. Charging batteries at a temperature below 41°F (5°C) will
10. Do not use batteries that have been exposed to heat
11. Do not use batteries that have suffered curvature or
12. Never fully discharge the battery packs (maximum
Protection from environmental influences
1. Wear suitable work clothes. Wear safety goggles.
2. Protect your cordless tool and the battery charger from
3. Do not use the cordless tool or the battery charger near
4. Use the battery charger and cordless tools only in dry
5. Do not keep the battery charger in places where the
6. Protect batteries from overheating. Overloads,
+
®
+ Sun Joe
®
®
7. Store the charger and your cordless tool only in dry
8. Prevent the lithium-ion battery packs from freezing.
9. When handling batteries, be wary of electrostatic
5
pack has already suffered dangerous damage
(exhaustive discharge).
cause chemical damage to the cells and may cause a fire.
during the charging process, as the battery cells may have
suffered dangerous damage.
deformation during the charging process or those that
exhibit other atypical symptoms (gassing, hissing,
cracking, etc.).
recommended depth of discharge is 80%). A complete
discharge of the battery packs will lead to premature
aging of the battery cells.
moisture and rain. Moisture and rain can cause dangerous
cell damage.
vapors and flammable liquids.
conditions and at an ambient temperature of 41ºF – 105°F
(5°C – 40.5°C).
temperature is liable to reach over 105°F (40.5°C). In
particular, do not leave the battery charger in a car that is
parked in the sunshine.
overcharging and exposure to direct sunlight will result
in overheating and cell damage. Never charge or work
with batteries that have been overheated – replace them
immediately, if possible.
locations with an ambient temperature of 41ºF – 105°F
(5°C – 40.5°C). Store your lithium-ion battery packs in a
cool, dry place at a temperature of 77°F (25°C). Protect
the battery packs, charger and cordless tool from humidity
and direct sunlight. Only place fully charged batteries in
storage (charged to at least 40%).
Battery packs that were stored below 32°F (0°C) for more
than 60 minutes must be discarded.
charge. Electrostatic discharges can damage the
electronic protection system and the battery cells. Avoid
electrostatic charging and never touch the battery poles.

Publicité

Table des Matières
loading

Table des Matières