Before Operating; To Set The Clock; Stop/Clear; Manual Operation - Dacor DCM24 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before operating your new microwave oven make sure
you read and understand this use and care manual
completely.
Before using the microwave, follow these steps:
1. Plug in the microwave oven. Close the door. The dis-
play will show
WELCOME PRESS CLEAR AND PRESS CLOCK
2. Touch the STOP/CLEAR pad. "
3. Set the clock.

To Set The Clock

1. Touch the CLOCK pad.
2. Enter the correct time of day by touching the numbers
in sequence. Touch the CLOCK pad again.
The microwave is equipped with a 12 hour clock. If you
attempt to enter an incorrect clock time,
in the display. Touch the STOP/CLEAR pad and re-enter
the time.

Time Cooking

Your microwave oven can be programmed for 99 minutes
and 99 seconds (99.99). Always enter the seconds after
the minutes, even if they are both zeros.
For example, to cook for 5 minutes at 100%.
1. Enter cooking time by touching the number pads
500.
2. Touch the START/INSTANT ON pad.

To Set power level

The microwave has 11 preset power levels.
Using lower power levels increases the cooking time
which is recommended for foods such as cheese, milk
and, long slow cooking of meats or defrosting. Consult a
cookbook or recipes for specific recommendations.
For example, to defrost for 5 minutes at 30%.
1. Enter the defrosting time by touching the number
pads 500.
2. Touch the POWER LEVEL pad and number 3.
3. Touch the START/INSTANT ON pad.

before operating

Heading
.
" will appear.
:
will appear
ERROR

Manual operation

E10
If electrical power to your microwave oven is inter-
rupted, the display will intermittently show
PRESS CLEAR AND PRESS CLOCK
restored. If power is interrupted during cooking, the
program will be erased. The time of day will also be
erased. Simply touch the STOP/CLEAR pad and reset
the clock for the correct time of day.

Stop/Clear

Touch the STOP/CLEAR pad to:
1. Clear a mistake made during programming.
2. Cancel the timer.
3. Stop the microwave oven temporarily during timed
cooking.
4. Return the display to time of day.
5. Cancel a program during cooking, touch twice for
timed cooking.
You can program up to 4 automatic cooking sequences.
Follow directions on page 22. Note that the power
level must be entered first when programming multiple
sequences.
TouCH powEr
approxIMaTE
lEVEl paD onCE
pErCEnTaGE
THEn TouCH
oF powEr
Power Level
9
8
7
6
5
4
3
2
1
0
WELCOME
after the power is
CoMMon
worDS For
powEr lEVElS
100%
High
90%
80%
70%
Medium High
60%
50%
Medium
40%
30%
Med Low/Defrost
20%
10%
Low
0%

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dcm24s

Table des Matières