Maintenance And Cleaning; Technical Assistance - VITO GARDEN VIRCR1000 Mode D'emploi

Maintenance and cleaning

Remove the battery from the power tool before start
cleaning, adjustment, repair or doing maintenance
work.
Replace worn out or damaged parts immediately so that
the power tool is always operational and in a safe
operating condition.
Cleaning:
Always keep the power tool clean and dry, free of oil,
grease and lubricants.
accessories of the power tool after use.
Do not use strong cleaning agents. These products can
damage plastics and metals and impair the safe
operation of your power tool.
Maintenance work:
Maintenance work may only be carried out as described
in these operating instructions, all other work must be
carried out by an official dealer.
Keep all nuts and screws well tighten so that the power
tool can operate safely.
If components or safety devices are removed for
maintenance work, they must be replaced correctly
immediately.
Use only attachable tools or accessories authorised by
VITO for this power tool or technically identical parts.
Otherwise injury or damage to the power tool may
occur. In case of doubt or if you lack the necessary
knowledge and means, you should contact an official
dealer.

Technical assistance

Your robot lawn mower should only be serviced by the
manufacturer's internal service personnel or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
36
Clean all components and
Read and
understand the
Instruction manual
before using the
Robot lawn mower
Warnings and
precautions
described in this
manual must be
carefully followed
so that the robot
can be used safely
and efficiently.
Maintenance and
inspection of the
robot should be
done with the
robot switched off.
Enter the PIN code,
to start the robot
and program it.