ASG HIOS BL Serie Mode D'emploi page 2

Push-to-Start Mode:
• BL-3000: Use tweezers to switch lever start to push-to-start
• BL-5000: Rotate the hex head screw to detach the switch lever
and set the start switch to the push position. Use it without
attaching the hex head screw and the switch lever.
• BL-7000: Rotate the hex head screw to detach the switch lever
and reattach the switch lever upside down.
6
7
6
6 Switch Lever
7 Hex Head Screw
Attaching a Bit
• Caution: When attaching the bit, always
ensure that the driver FOR/OFF/REV
switch is set to OFF or that the driver
power plug has been removed from the
AC power outlet.
• Use the correct bit size. To install the bit,
push or pull the joint shaft collar at the end
of the driver upwards and insert the bit.
Check that the bit does not come loose
after you have inserted it.
Torque Adjustment Procedure
• Use the torque adjustment nut to select the desired
output setting. Note that this setting should be taken as
an approximate value. Adjust the setting by loosening the
adjustment nut stopper and adjusting the torque adjustment
nut. When the setting has been made, re-tighten the torque
adjustment nut stopper securely. Repeat this process to
determined the appropriate tightness. Use a torque tester to
verify.
• The BL-2000 has a double nut system (nut fixing ring and torque
adjusting nut) to avoid loosening from shock or vibration to the
screwdriver.
• BL-3000: Make the setting by pushing the nut collar upwards,
remove the torque adjustment nut, and turn it so the point
over the nut aligns with the groove.
• BL-5000, BL-7000: Set the torque adjustment nut using the hex
wrench that is provided.
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
HIOS BL Series
Operational Manual
7
8 Joint Shaft
Collar
| Phone: (
44110-3898 888) 486-6163
1
2
3
1 Torque Scale
2
Nut Securing Ring
3 Torque Adjustment Nut
4 Torque Adjustment Scale
5
5mm hex nut L Wrench
Repairs
Contact ASG with any questions or concerns at +1-888-486-6163 or
asginfo@asg-jergens.com
8
| Fax: ( | Email: asginfo@asg-jergens.com | Web: www.asg-jergens.com
216) 481-4519
4
2
3
5