Blomberg BOTR30200CSS Manuel D'installation page 15

Installation
5
Plate position—beneath framed recessed
cabinet bottom
NOTE: IT IS VERY
READ IMPOR
IN THE AND FOLLO TANT TO
BEFOR INSTA LLATIO W THE DIREC
REAR E PROCE N INSTR TIONS
WALL TEMPL EDING WITH THIS UCTIO NS
This Rear Wall Template ATE. 3/8" TO EDGE
mounting plate and serves 12"
outlet. to locate the horizonta to position the bottom
1. Use a level to check l exhaust
2. Locate accuratel y. that the template
right side and mark at least is positione d
of the centerline one stud on the left 4"
screw mounted It is important . or
of the microwav firmly in to use at least one
locations e. Mark a stud to two additiona support wood
3. Drill holes for the supplied toggle bolts. l, evenly the weight Trim the
a stud, drill a 3/16" in the marked locations. spaced
that do not line hole for wood screws. Where there is
toggle bolts. up with a stud, For holes
DO NOT drill 5/8" holes for
AT THIS TIME. INSTALL THE MOUNTIN
5. Review 4. Remove the template G PLATE
installatio the Installatio from the rear wall.
n situation. n Instructio n book
for your
versión Darle vuelta a la hoja
en Español para consulta
. r la
Locate
mounti and mark holes to
ng plate. align with
IMPOR TANT: holes in the
LOCAT
THE CENTE E AT LEAST
RLINE ONE STUD
MARK THE LOCAT . ON EITHE R SIDE
SPACE ION FOR OF
AREA. D TOGG LE BOLTS 2 ADDIT
IN THE IONAL , EVENL
MOUN TING PLATE Y
Trim the rear wall
templa
te along the dotted
line.
Locate
mounti and mark holes to
ng plate. align with
IMPOR TANT:
LOCAT
THE CENTE E AT LEAST
RLINE ONE STUD
MARK THE LOCAT .
SPACE ION FOR
D TOGG LE BOLTS
AREA. IN THE
C L
Draw a vertical line on the wall at the center of the
30 space.
ʺ
Tape the Rear Wall Template onto the wall
matching the centerline and touching the bottom
cabinet frame.
Plate position—beneath recessed bottom
cabinet with front overhang
NOTE : IT IS
READ AND FOLLO VERY IMPOR
IN THE W THE TANT TO
BEFOR INSTA LLATIO DIREC
REAR E PROC EEDIN N INSTR UCTIO TIONS
WALL TEMP G WITH NS
mounting This Rear Wall Template LATE. THIS 3/8" TO EDGE
outlet. plate and serves to position 12"
1. Use to locate the horizonta the bottom
accurate a level to check l exhaust
2. Locate ly. that the template
right side and mark at least is positione d
It is importan of the centerline one stud on the 4"
screw mounted t to use . left or
of the microwav firmly in a stud at least one wood
locations for the e. Mark two additiona to support the weight
3. Drill holes in the marked supplied toggle l, evenly spaced
that do a stud, drill a 3/16" locations bolts. Trim the rear wall
toggle not line up with hole for wood screws. . Where there is templa
bolts. a stud, drill 5/8" For holes te along
AT THIS DO NOT INSTALL holes for the dotted
4. Remove TIME. THE MOUNTI line.
5. Review the template NG PLATE
installatio the Installatio n Instructio from the rear wall.
n situation. n book for your
Darle vuelta
versión en Español a la hoja para consulta
. r la
Locate
and mark
mount ing plate. holes to
IMPOR align with holes in
LOCAT TANT: the
E AT LEAST
THE CENTE ONE STUD
MARK RLINE . ON EITHE
THE LOCAT R SIDE
SPACE D TOGG ION FOR OF
AREA. LE BOLTS 2 ADDIT IONAL
IN THE MOUN , EVENL
TING PLATE Y
Trim the
rear wall
templa te along
the dotted
line.
Locate
and mark
mount ing plate. holes to align with
IMPOR TANT: holes in
LOCAT the
E AT LEAST
THE CENTE ONE STUD
MARK THE LOCAT RLINE . ON EITHE
SPACE ION FOR R SIDE OF
D TOGG 2 ADDIT
AREA. LE BOLTS IN THE IONAL
MOUN , EVENL Y
TING PL
Your cabinets may have decorative trim that inter-
feres with the microwave installation. Remove the
decorative trim to install the microwave properly
and to make it level
Over The Range Convection Microwave Oven / Installation Manual
rear wall
templa te along
the dotted
line.
holes in the
ON EITHE R SIDE
OF
2 ADDIT
IONAL , EVENL
MOUN TING PLATE Y
33 to Cooktop
ʺ
Draw a line on the
back wall equal to the
depth of the front
overhang.
NOTE: IT IS VERY
READ IN THE AND FOLLOW IMPORTANT
REAR BEFORE INSTALLAT PROCEEDIN ION INSTRUCTI THE DIRECTION TO S
This Rear WALL TEMPLATE G WITH THIS ONS 3/8" TO EDGE
mounting outlet. Wall Template plate and to locate serves . to position 12"
1. Use accurately. a level to check that the the horizontal exhaust the bottom
2. Locate right side and mark of the centerline. at least template one stud is positioned 4"
screw mounted of the microwave. It is important to use at least on the left or
3. Drill locations for the firmly in Mark two supplied a stud to support additional, one wood the weight
a stud, that do drill a 3/16" holes in the marked toggle locations. bolts. evenly spaced Trim the rear wall
toggle not line bolts. up with a stud, hole for wood screws. drill 5/8" Where there is For holes template along
AT THIS 4. Remove DO NOT TIME. INSTALL THE MOUNTING holes for the dotted line.
5. Review installation the Installation the template from the rear wall. PLATE
situation. Instruction book for your
versión Darle vuelta a la hoja
en Español. para consultar la
mounting Locate and mark
IMPORTAN plate. holes to align with holes in
LOCATE AT LEAST T: the
THE CENTERLIN MARK E. ONE STUD ON EITHER
SPACED THE LOCATION TOGGLE FOR 2 SIDE OF
AREA. BOLTS IN THE ADDITIONA MOUNTING L, EVENLY
PLATE
Trim the
rear wall template
along the dotted line.
Locate
mounting and mark plate. holes to align with
IMPORTANT LOCATE : holes in the
THE CENTERLIN AT LEAST ONE STUD
SPACED MARK THE LOCATION E. ON EITHER SIDE OF
AREA. TOGGLE BOLTS FOR 2 ADDITIONA
IN THE MOUNTING L, EVENLY
PLATE
C L
33" to Cooktop
The microwave must be level.
Use a level to make sure the cabinet bottom is lev-
el.
If the cabinets have a front overhang only, with
no back or side frame, install the mounting plate
down the same distance as the front overhang
depth. This will keep the microwave level.
1. Measure the inside depth of the front overhang.
2. Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside
depth of the front overhang.
3. For this type of installation with front overhang
only, align the mounting tabs with this
horizontal line, not touching the cabinet bottom
as described in subtitle 5.1.4.
15 / 63 EN