Installing And Removing Flat Panel Screen - PEERLESS SmartMount ST 632P Mode D'emploi

Installing and Removing Flat Panel Screen

Attach screen to tilt assembly (B). Tighten M5 x 6
3
mm screw (J or N) to lock screen to tilt assemby.
For security installation tighten M5 x 6 mm socket
pin screw (N) using 4 mm security driver (O) to lock
screen to tilt assemby.
To remove screen from mount, loosen screw (J or N)
and lift screen off of mount.
WARNING
• Do not lift more weight than you can handle. Use
additional man power or mechanical lifting equipment
to safely handle placement of the screen.
• Failure to lock hook bracket (A) with screw (J) can
cause screen to come off mount if hit accidentally.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
Adjusting the Tilt Angle of the Flat Panel Screen
Adjust tension knob on right side of mount shown in
4
figure 4.1 to desired tension to balance your screen
size and weight.
Note: If knob is inaccessible, remove screen from
mount, adjust tension knob to desired tension to
balance your screen size and weight, and reattach
screen to mount as stated in step 3.
Push or pull from top or bottom of screen to adjust
tilt as shown in figure 4.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
Note: To lock the screen into the desired tilt
position, tighten tension screw on left side of mount
shown in figure 4.2 using phillips screw.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Be careful not to pinch fingers when pushing screen
from the bottom.
fig. 4.1
8 of 16 ISSUED: 05-11-05 SHEET #: 201-9476-6 02-26-07
All other brand and product names are trademarks or registered trademarks of their respective owners.
SCREEN
J or N
B
fig. 3
TENSION KNOB
TENSION SCREW
© 2007, Peerless Industries, Inc. All rights reserved.
A
fig. 4.2