Table Des Matières; Tools Needed For Assembly; Accessories - PEERLESS SmartMount ST 632P Mode D'emploi

Note: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings con-
tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless
customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never mount this product to a metal stud wall construction unless the stud can be verified to be constructed of 25
gauge steel minimum, the drywall is 1/2" thick minimum and you obtain and use the Peerless accessory kit for metal
studs.
• Never exceed the Maximum UL Load Capacity.
• If mounting to wood wall stud wall construction, make sure that mounting screws are anchored into the center of the
studs. Use of an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power. See suggested torque values where applicable within these instructions.

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 1/4" bit for concrete and cinder block wall
• 1/2" bit for metal stud wall
• 5/32" bit for metal or wood stud wall
• level

Accessories

• Metal Stud Fastener Kit (ACC 215) (Not evaluated by UL)
• Video Conferencing Shelf (ACC 309) (Not evaluated by UL)
• Accessory Shelves (PM 600, PM 610) (Not evaluated by UL)
Table of Contents
Parts List .............................................................................................................................................................................. 3
Installation to Single Wood Stud Wall ................................................................................................................................... 4
Installation to Solid Concrete or Cinder Block ....................................................................................................................... 5
Attaching Adapter Plate to Screen with VESA 200 or 200 x 200 Mounting Pattern .............................................................. 6
Attaching Hook Bracket to Screen with VESA 75 or 100 Mounting Pattern .......................................................................... 7
Installing and Removing Flat Panel Screen ........................................................................................................................... 8
For customer care call (800) 865-2112 or (708) 865-8870.
WARNING
2 of 16 ISSUED: 05-11-05 SHEET #: 201-9476-6 02-26-07