Rockford Fosgate 3SIXTY Installation Et Fonctionnement page 7

5. Prepare the REM (remote) wire for for attachment to the power connector by stripping 1/4" (6.4mm) of
insulation from the end of the wire. Insert the bared wire into the REM terminal and tighten the setscrew to
secure the wire in place.
Used as an input: Connect the other end of the REM wire to a switched 12 volt positive source.The
switched voltage is usually taken from the source unit's remote amp on lead.
Used as an output: You will need to contact customer service for proper procedure to reconfigure the
unit to set the REM as an output.
6. Securely mount the 3Sixty unit to the vehicle and insert the power connector into the 3Sixty.
Input Connection
CAUTION: Use only one input configuration. Using both the RCA and High Level inputs will
cause undesirable operation.
IMPORTANT: The 3Sixty can be set up to create a 6-channel output with only 2-channels (Left and Right) of
input. However, for the best sound stage, it is strongly recommended to connect into all of the
main inputs (AUX not required). If you are not using all 6 inputs (Front/Rear Left and Right,
Center and Sub) the system will either SUM the inputs during New Setup or ask you if
you want to SUM the inputs during OEM Integration. Keep in mind that if you choose to
use SUM, all left channels will form one signal and all right channels will form one signal.
Stereo imaging will be maintained but your fader will cease to function. If you choose not
to sum, any audio inputs not used will not have audio on their output.
RCA Input Connection
7. Connect the RCAs from the source unit into the
input jacks at the left side of the 3Sixty.
High Level Input Connection
CAUTION: Ensure to maintain signal
polarity when using the high
level inputs. Failure to do so
may cause undesirable phasing
effects.
8. Connect the high level inputs (speaker) from the
source unit into the matching connections of the
connector for the 3Sixty High Level Input. Strip the
wires 1/4" (6.4mm) and insert into the connector
terminal and tighten the setscrew to secure into
place. Be sure to maintain proper polarity.
DO NOT chassis ground any of the leads as
unstable operation may result.
NOTE: Follow the diagram for proper signal polarity.
9. Insert the wired connector into the High Level Input
port on the 3Sixty.
RCA Output Connection
10. Use RCA cables to connect the output jacks of the 3Sixty to the input jacks on the amplifier you have
selected for your system.The 3Sixty will allow you to connect 6-channels of output.
11. Follow the instructions in your amplifier manual for
connecting the rest of your system.
12. Perform a final check of the completed system
wiring to ensure that all connections are accurate.
Check all power and ground connections for
frayed wires and loose connections which could
cause problems.
COMM PORT Connection
13. DO NOT connect the remote into the COMM
PORT at this time. OEM Integration and New Setup
needs this disconnected for proper system
integration.
RCA Input
from Source
Auxillary
Input
I
NSTALLATION
Strip 1/4"
High Level Input
(0.25)
from Source
(6.4mm)
RCA Output
to Amplifier
7