Connection To Mains - Ecotec ECOPOINT Manuel D'instructions

ECOPOINT USER MANUAL / MANUEL D'INSTRUCTIONS
B) CONNECTION TO MAINS
The charger UL-listed, is manufactured without charging cable. Connection to mains has to be performed only
by skilled personnel.
There are some pre-engraved holes on the charger with the diameters listed in the table below. The table
shows the diameter of the strain relief for each kind of hole and the diameter of the power cord which it is
suitable for.
The person connecting charger to mains has to correctly dimension the power cord, depending on the input
fuse as described on the rating plate. In addition he has to decide which fairlead has to be used and in which
hole the fairlead has to be installed.
The holes dedicated to the path of the power cord are located on the left side of the battery charger.
The cord has to follow a guided path inside the charger by passing through three straps, two of which are
preinstalled on the bottom and the third one is located on the back panel, and by keeping close to the left side
of the unit.
Then it has to rise along the back panel up to the entry connector.
Once the entry connector has been reached, the connection has to follow the arrangement as shown on the
label set above the connection terminals.
The input cord has to be secured so as not to touch sharp metal parts or heating elements (such as the power
transformer).
As shown on the labels, use copper conductors rated min. 75° C.
This Picture shows how mains connection to LP
cabinets is performed
Intended Conduit
Size (inches)
½
¾
1
pag. 2
file: MU120037_MAN UT_ENERPOWER-PULSE_ECOTEC
Hole Diameter
(mm)
22.2
27.8
34.5
This Picture shows how mains connection to L
cabinets is performed
Revisione n° 2 del 2015/01/14
USA REV2.DOC