Ecotec ECOPOINT Manuel D'instructions page 10

ECOPOINT USER MANUAL / MANUEL D'INSTRUCTIONS
Where :
OFF = LED is OFF
ON = LED is ON fix
BLK = LED blinks slowly (T= 2sec)
FLASH = 1 quick blink followed by a pause (Ton = 0,5 sec, Toff = 1,5 sec)
ROT FLASH2 = Leds flash in sequence
NO CHANGE = Led hold the previous state
*N.B. : It is recommended to switch on power before connecting the battery to avoid any power failure alarm.
H.2) LCD VISUALIZATIONS
Charging current
Battery Voltage (V/el)
Battery level
Phase of Charge :
I
= Initial Charge
F
= Final Charge
E = End of Charge
B = Balance Charge
H.3) LIST OF FAILURES SHOWN ON ALPHANUMERIC DISPLAY
Below you will find a list of the failures displayed
MESSAGE DISPLAYED
Low battery voltage
High battery voltage
Timeout Initial Charge
Timeout Overall Charge
Battery disconnection
Interruption by key depression
Air blow failure
Mains interruption
Power failure
I) GUARANTEE
The charger is guaranteed for 12 months from the date of installation.
-
The guarantee covers all proven defects in components, assembly, and construction.
-
Any incorrect installation or use of the machine NULLIFIES the guarantee.
-
Any unauthorised tampering NULLIFIES the guarantee.
-
In case of difficulties please contact the LOCAL DEALER or ECOTEC Ltd.
-
Battery voltage too low for that battery charger: wrong battery connected
Battery voltage too high for that battery charger: wrong battery connected
Operation of safety timer - Initial Charge
Operation of safety timer - Overall Charge
Please note! Disconnection of battery during the charging process
Charge interruption due to ON/OFF key depression
Failure in the airpump system
Mains voltage interruption
Power failure: delayed charge start
pag. 9
file: MU120037_MAN UT_ENERPOWER-PULSE_ECOTEC
Revisione n° 2 del 2015/01/14
DESCRIPTION
Charged Ah
Charging Time
USA REV2.DOC