Operation; General Operation - Klarstein 10031663 Mode D'emploi

OPERATION

General Operation

After removing all interior and exterior packaging materials, use hot water to
1
clean the aluminum bowl and top lid of ice cream maker before using.
Please correctly connect the input connector clip of the adaptor into the ice
2
cream maker, and then insert the power plug into the power socket. Make
sure the power socket is 100-240 V 50/60 Hz AC.
For good taste, by using measuring cup or spoon to ensure that you get the
3
correct dose for each ingredient with your choice.
Pour all the ingredients into the bowl of ice cream maker, do not exceed the
4 maximum limit of 300 ml marked on the bowl, stir them well and then close
the lid.
5 Allow 1-2 hours of operation, the maker beeps once done.
Unplug ice cream maker the wall outlet if it is not to be used for an period of
6
time.
Cooling Performance
• The temperature at the aluminum bowl be cooled to minus 15°C in 2 hours (with the
unit empty).
• Inside the ice cream maker with full load , It will take about 2 hours to finish the ice
cream if the appliance are stabilized at a room temperature of 25°C.
EN
17