Aquaglide C-DECK Manuel De L'utilisateur page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note
original folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way
airflow) position (see HR Valve Operation Graphic).
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use
pump to inflate Main Valve [1] to Working Pressure as shown in Chart 1. Check for proper
pressure using gauge (manometer). Replace valve cap.
4.Since this item will be attached to another, follow steps below to prepare connections
prior to launching. When connecting multiple items together follow guidelines carefully. Use
only Two-Step Vario-lock cinch straps and Aquaglide connecting rings.
a. C-Deck is a 'connector' item. Straps should first be attached to 'Connector'
items (example: Swimstep, Splashmat, Speedway, Breezeway or Deck) only where a
connection is needed. Use all of the straps supplied with connector.
b. 'Connector' items generally go between or attach to feature items. Connectors
should not be attached to other connectors.
c. Use all available rings to make connection. Standard connections use 5 rings.
Some items use 3 or occasionally 7 rings/ straps. C-Deck is a connector with 3-rings on 1
end.
d. After launch instructions (below), float 'Connector' with necessary straps
attached into desired position. Note: a matching set of connecting rings is required on
feature item.
e. Attach center strap to center ring on feature item. Connect loosely, then work
outward until all straps are connected.
f. Dive beneath to tighten all straps securely. Dive mask and several attempts may
be required. Make sure connection is tight and there is NO GAP between items. Failure to
connect items properly may result in injury or death. See D1 through D6.
D-1
D-4
5. To launch product, lift completely and place in water. Never drag product as damage may
occur. Confirm that suitable anchor(s) and mooring lines are in place before launching this
item.
7
D-2
D-5
D-3
3
1
2
0mm
D-6
5X
www.aquaglide.com

Publicité

Table des Matières
loading

Table des Matières