Heating Up; Refi Lling - EHV Kanuk 1 Mode D'emploi

2.5 Heating up

Fully open the control valve in the exhaust gas stub, the primary air
vent in the combustion chamber door, and the secondary air vent
in the rear wall. For heating up, stack the fi rewood in a pyramid over
screwed paper and cover it in thin logs of wood. Then start the fi re.
After heating up, fi ll up the Kanuk® hot-air kiln with logs according
to chapter 2.1.
Note: Kanuk® hot-air kilns are coated in high quality heat-resistant
paint. During the fi rst phase of heating up, the burn-in of the paint may
result in slight smoke development and odor nuisance. Make sure to
keep your windows and doors open when heating up the kiln for the
fi rst time.
Before the fi rst heating-up, make sure to check the correct instal-
lation of the viewing window of the Kanuk® hot-air kiln. The screws
for the hanger on the front side of the combustion chamber door
must be tightened to the degree that the door remains movable
(hand-tight).

2.6 Refi lling

Open the primary air vent in the combustion chamber door and
the secondary air vent in the rear wall and set the control valve
in the exhaust gas stub to position A. Then open the combustion
chamber door and fi ll with wooden logs until reaching the rear wall.
Make sure to leave enough space underneath the logs, as that will
prevent the fi re from being choked. Then close the com-
bustion chamber door. Once the logs are well burnt, you can consider
curtailing the primary and secondary air vent to facilitate a more
regular burn-off . Make sure to leave the primary air vent open at all
times for the pane ventilation to function without interference.
EHV GmbH • Entwicklung | Herstellung | Vertrieb • Hauptstraße 131 • 01744 Dippoldiswalde
DIRECTIONS OF USE
21