General Picture (Video) Adjustment For An Av Source - Pioneer KURO PDP-6020FD Mode D'emploi

Basic Operations For Television Viewing

3.4.2 General Picture (Video) Adjustment for an AV Source

The directions below apply to all AV sources except OPTIMUM and DYNAMIC. If the viewing option is OPTIMUM,
your flat panel TV automatically adjusts the picture to the best possible level. If the preferred viewing option is
DYNAMIC, please refer to "4.1 Choose an AV Option (Video, Game, etc.)." For standard picture adjustments, follow
the steps below.
1 ) Access the Picture
2 ) Select an item to be adjusted.
Contrast is used in the example below.
3 ) Use the arrow buttons (/) to adjust to the desired level.
4 ) Press HOME MENU to exit the menu.
Reduce Noise from Analog TV
Sometimes electronic signal static can cause imperfections in the picture. This static is called Video Noise. Your
flat panel TV can reduce video noise from an analog TV channel, depending on the broadcast signal level.
Sometimes the broadcast signal has higher interference levels so that some video noise is noticeable.
This function is only selectable for signals from an antenna. Follow the steps below to reduce noise on an analog
TV channel.
System Setup
1 ) Access the
Analog TV Setup
2 ) Select
Manual Adjust
3 ) Select
Only analog channels set using Auto Installation are manually adjustable.
Program Entry
4 ) Select
5 ) Select a channel number to be added.
Use the arrow buttons (
Tuner NR
6 ) Select .
On
7 ) Select .
The default setting is On.
8 ) Press HOME MENU to exit the menu.
through the Setup .
Picture
AV Selection
Contrast
Brightness
Color
Tint
Sharpness
PureCinema
Reset
Contrast
Setup
through the .
from the System Setup menu.
from the submenu.
.
/
) to enter a channel number.
: PERFORMANCE
: 40
: 0
: 0
: 0
: 0
32
03
43
En