LG LTCS20220 Serie Manuel D'utilisateur page 24

Problem
The power supply cord is unplugged.
A household fuse has blown or a
circuit breaker has tripped.
The refrigerator control is set to the
OFF position.
Refrigerator is not
cooling.
The refrigerator is in the defrost cycle.
The OFF light is illuminated.
The power supply cord is unplugged.
Lights do not
work
An LED light has malfunctioned.
Vibration or The refrigerator is not resting solidly
rattling on the floor.
noise.
The refrigerator that was replaced was an
older model.
The room temperature is warmer
than normal.
The door is opened often or a large
amount of food has just been added.
Compressor
seems
to run too much.
The refrigerator was recently plugged in
and the refrigerator control was set
correctly.
The refrigerator control is not set correctly
for the surrounding conditions.
The doors are not closed completely.
The back cover is dirty.
TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE
Possible Causes
23
Solutions
Firmly plug the cord into a live outlet with
proper voltage (see Electrical & Grounding
Requirements).
Replace the fuse or reset the circuit
breaker. If the problem persists, contact
an electrician.
Refer to the Setting the Controls section.
Wait about 30 minutes for defrost cycle
to end.
The refrigerator is in DEMO mode. The Demo
Mode disables the cooling system and only
the lamps and display will work normally. To
disable Demo Mode, press the Temperature
Adjust button until you set the desire
temperature level. When demo mode is deac-
tivated, the OFF light
Firmly plug the cord into a live outlet
with proper voltage (refer to Electrical &
Grounding Requirements).
Before proceeding to replace LED, unplug the
refrigerator or turn off power at the circuit
breaker or fuse box.
NOTE: The refrigerator and freezer
compartment lamps are LED interior lighting,
and service should only be performed by a
qualified technician.
Floor is weak or uneven or leveling legs need
adjusting. See the Installation section for
leveling instructions.
Modern refrigerators require more operating
time but use less energy due to more efficient
technology.
The compressor will run longer under warm
conditions. At normal room temperatures
(70°F) expect your compressor to run about
40% to 80% of the time. Under warmer
conditions, expect it to run even more often.
The refrigerator should not be operated in
surrounding temperatures above 110°F.
Adding food and opening the door warms the
refrigerator, requiring the compressor to run
longer in order to cool the refrigerator back
down. In order to conserve energy, try to get
everything you need out of the refrigerator
at once, keep food organized so it is easy to
find, and close the door as soon as the food is
removed. (Refer to the Food Storage Guide.)
The refrigerator will take up to 24 hours to
cool completely
See the Adjusting Control Settings section.
Firmly push the doors shut. If they will not
shut all the way, see "Doors will not close
completely" in the Troubleshooting section.
This prevents air transfer and makes the motor
work harder. Clean the back cover. Refer to
the Care and Cleaning section.
will turn off.