Notes To Usa Users Of Fcc Requirements - Ricoh D8600 Mode D'emploi

In accordance with the Battery Directive 2006/66/EC Article 20 Information for end-users Annex II,
the above symbol is printed on batteries and accumulators.
This symbol means that in the European Union, used batteries and accumulators should be disposed of
separately from your household waste.
In the EU, there are separate collection systems for not only used electrical and electronic products but
also batteries and accumulators.
Please dispose of them correctly at your local community waste collection/recycling centre.

Notes to USA Users of FCC Requirements

Note:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Declaration of Conformity
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Responsible party: Ricoh USA, Inc.
Address: 70 Valley Stream Parkway Malvern, Pennsylvania 19355
Telephone number: 610-296-8000
Product Name: Interactive White Board
Model Number: Interactive White Board D8600
Using the shield cable
Properly shielded and grounded cables and connectors must be used for connections to a host computer
(and/or peripheral) in order to meet FCC emission limits.
Laws and Regulations
15