Texas A/S Power Split 2000 VH Guide D'utilisation page 27

Step 9: Attach Wheel Fenders
Attach left fender (#72) and right fender(#74) by using hex bolt M10x30 (#73), flat washer
Ø10 (#97), lock washer Ø10 (#33) and lock nut M10 (#32).
Step 10: Attach Hydraulic Hoses
1. Thread the outlet connector (#59) to the top of the gear pump (#47). Use Teflon tape to
ensure tight fit.
2. Place an O ring (#61) onto the exposed threads of the outlet connector. Then attach
hose (#13) to outlet connector.
3. Attach hose (#15) to the port on the oil tank. Place an O ring (#61) on the port and
tighten the hose using Teflon tape.
4. Attach the oil pipe (#60) to the bottom of the gear pump (#47) by the clamp (#78).