Reggiani SPLYT Guide D'installation page 16

Splyt | ENG |
(PHOTO N).
Lastly, replace the cover (PHOTO I).
TRIMLESS SEMI-RECESSED LUMINAIRES
The generously proportioned spotlight
bezel can be used to install the luminaires
in false ceilings of varying thicknesses.
First of all prepare the recess housing of
the appropiate dimension:
• trimless recessed luminaires 120 mm:
130x130 mm
• trimless recessed luminaires 150 mm:
160x160 mm
• depth: 110 mm
as shown on the specific label.
Insert the spotlight bezel into the cut-out
(fig.1), and use the screws supplied to fix
it in place (fig.2).
After mounting the spotlight bezel and
before plastering to fi nish the recessed
housing, tape the bezel to protect it, then fi
nish the housing with plaster and smooth
perfectly around the cut-out (fig.3).
Remove the cover of the driver compart-
ment with screwdriver or similar (PHOTO
F); connect the driver to the mains power
supply (PHOTO L); insert the steel safety
cable into the luminaire, then into the bez-
el aperture (PHOTO M);
use the screws supplied to attach the
luminaire to the bezel (PHOTO N) and re-
place the cover (PHOTO I).
www.reggiani.net
N
4
5
016
SEMI-RECESSED LUMINAIRES WITH BE-
ZEL
First of all, prepare a recess of the appro-
priate size:
• Semi-recessed with bezel 120 mm:
130x130 mm
• Semi-recessed with bezel 150 mm:
160x160 mm
• depth 110 mm
as shown on the specific label.
To assemble/disassemble the bezel, turn
the spring clip upwards with the help of a
screwdriver or similar inserted between
the spring and the pin (fig.7-8), fi t the bez-
el into the cut-out (fig.9), and press on the
spring until it clicks into place (fig.10).
Remove the cover of the driver compart-
ment with screwdriver or similar (PHOTO
F); connect the driver to the mains power
supply (PHOTO v); insert the steel safe-
ty cable into the luminaire, then into the
bezel aperture (PHOTO X); use the screws
supplied to attach the luminaire to the
bezel (PHOTO Y) and replace the cover
(PHOTO I).