Reggiani SPLYT Guide D'installation page 15

Splyt | ENG |
wall (PHOTO G ) and wire the luminaire to
1
the mains power supply with appropriate
connectors (PHOTO H) Lastly, replace the
cover (PHOTO I).
WALL MOUNTED, SEMI-RECESSED LUMI-
NAIRES WITH BEZEL
To assemble the wall mounted plastic
bezel supplied it is necessary to prepare a
recess of the appropriate size in the wall:
• Wall mounted, semi-recessed with bez-
el 120 mm: 145x145mm
• Wall mounted, semi-recessed with bez-
el 150 mm: 175x175 mm
• depth: 62mm.
The generously proportioned spotlight
bezel can be used to install the luminaires
in false ceilings of varying thicknesses.
Insert the spotlight bezel into the cut-out
(fig.1), and use the screws supplied to fi
x it in place.
After mounting the spotlight bezel and
before plastering (fig.2) to finish the re-
cessed housing, tape the bezel to protect
it, then finish the housing with plaster
and smooth perfectly around the cut-out
(fig.3).
Remove the cover of the driver compart-
ment with screwdriver or similar (PHOTO
F); wire the luminaire to the mains pow-
er supply with appropriate connectors
(PHOTO L); insert the luminaire into the
installed bezel (PHOTO M); use the screws
supplied to fix the luminaire in place
www.reggiani.net
I
1
2
015
3
L
M