Signal Led - DeLorme inReach Guide De Démarrage

that the emergency has been resolved and assistance is
no longer needed.
IMPORTANT! You must cancel SOS to stop GEOS
from sending help. Turning off the inReach device or a
connected device or taking out the batteries will NOT
tell GEOS to stop the rescue. If you replace the batteries
when an SOS is in progress, press and hold the SOS
button again to update your location.
Visit geosalliance.com for more information about GEOS.

Signal LED

The Signal LED indicates the status of the connection
between the inReach and the GPS satellites or Iridium
satellites. Green flashes indicate that messages or
tracking points are being sent. Red flashes indicate that
you don't have a good signal and messages or tracking
points aren't being sent.
• The Signal LED flashes green once every three
seconds when the inReach is sending a message
of any type. The LED will stop flashing when the
message is sent unless the inReach is tracking in
standalone mode.
• The Signal LED flashes red once every three seconds
when there is a problem sending or confirming a
6
message. The Signal LED will flash red until the
message is successfully transmitted or cancelled.
If the LED is flashing red, try moving to a new location
to get a better view of the satellites.
Message LED
The Message LED flashes when you send a message; it
stops flashing when the message has been sent.
The Message LED also flashes when a message has
been sent to you. You can view incoming messages on a
paired mobile device or on explore.delorme.com.
Using the Earthmate App
When you pair your inReach with the Earthmate app,
you can use your compatible smartphone or mobile
device to send and receive messages when you are out
of cell phone range—whether you just want to share
your trip, check in with loved ones, or send an SOS in an
emergency.
• Download and install the Earthmate app for your
device.
• Bluetooth must be enabled on your smartphone or
®
mobile device to pair or connect it to the inReach.