Lcd And Control Panel; Remote Control - ECOVACS DEEBOT D77 Manuel D'instructions

2.4 LCD and Control Panel

Model D77
1. Battery Display
2. Indicator - Dust Box Full
3. Indicator - Dust Box Missing
4. Indicator - Trapped Item
5. Indicator - Driving Wheel Suspended
6. Start/Pause
7. Mode Selection

2.5 Remote Control

Note
Please make sure the Remote
Control's batteries are properly
installed and power switch at the
bottom of the robot is ON.
During direction control, the
robot is not able to clean.
Remove batteries if Remote Control will not be used for a long time.
EN
8. Pause Status
9. Spot Cleaning Mode
10. Return to Charger Mode
11. Edge Cleaning Mode
12. Intensive Cleaning Mode
13. Automatic Cleaning Mode
14. Operation Status
Start/Pause Button: start or pause the robot.
Direction Control Button: push and hold the appropriate button to drive the robot in
any direction.
Mode Selection Button: according to conditions, choose different cleaning modes
(please refer to section 3.3 "mode selection").
Mode
15. Cancel Scheduled Cleaning
16. Daily Scheduled Cleaning
17. One Time Scheduled Cleaning
18. Time Adjust Button
19. Set Cleaning time
20. Current Time Setting Status
21. Time display
When using the Remote
Control, be sure to point it
towards the infrared signal
receiver on the robot, and be
within 16 feet of the robot.
The charging dock or other
sources that use an infrared
signal may interfere with the
Remote Control signal.