Abus TVAC70200 Mode D'emploi page 9

2.2. Installing the joint component
2.2.1. Take the loose joint component and
2.2.2. Insert the joint component into the
2.3. Installing the bottom case
2.3.1. Make sure that only the bottom case of
2.3.2. Remove the PVC nuts from the PG
2.3.3. Guide the cables you are using out of
2.3.4. Connect the cables to the contacts
2.3.5. Guide the PG nuts onto the PG screws,
guide the cables you are using out of
the wall bracket, into the lower joint
opening of the joint component and then
through the component.
holding point of the wall bracket at an
angle (of approx. 45°) and use the
hexagon screw to fix it to the bottom of
the wall bracket.
the weatherproof housing is used for the
following installation steps (if necessary,
separate the top case from the bottom
case).
screws on the bottom case.
the joint component opening, then
through the loose PG nuts and finally
through the PG screws.
provided for this purpose inside the
bottom case. There is a detailed
description of this step in the following
section.
and screw them together.
9