Bartscher Kompakt 300 Mode D'emploi page 31

•
Make sure that no flammable substances are stored or used in the vicinity of the
device.
•
The device must not be started in the toxic or explosive environment.
Installation of the condensation hood
•
Put the condensation hood on the upper cover of the combi-steamer (section
4.2 "Technical data") and assure good adherence. Make sure that the supply
cable is not blocked between the devices.
•
Remove the protective foil from the device before use. Remove the foil slowly in
order to not to leave the glue residuals. Any glue residuals may be removed with use
of proper solvent.
CAUTION!
Never remove the rating plate or any warning signs from the device.
Connecting to the extraction connection
•
The spiral pipe is located on
the back wall of the condensation hood
and should be inserted to the extraction
connection of the combi-steamer.
Steam is collected and removed during
the operation of the condensation hood.
Connecting to the drain
•
Connect the drain hose (not included)
to the dripping trough. Hose should
have internal diameter of 20 mm.
Fix the hose with use of clamping
band.
Spiral pipe
Extraction
connection
combi-steamer
Dripping trough
for condensed
water
- 27 -