Climate Screens - Dometic Interact Manuel D'utilisation

Operation

4.1.2 Climate Screens

The Climate screens allow you to control and monitor the
climate within your RV, such as cooling, heating, and
vents.
2 Climate Screens
6
From these screens, you can control or monitor the
following functions:
• Current Temperatures: These indicate the current
indoor and outdoor air temperatures.
The outdoor temperature sensor may not be
I
available on all models.
• Power: The default state for this button is off. Tap the
toggle button once to turn climate control on. The
applicable climate control appliance will be activated,
depending on the set temperature and the
temperature type currently selected.
• Set Temperature: This area displays a set of numbers
ranging from 40–90 °F (4–32 °C), in ascending order.
Use the tumbler to select your desired temperature
setting.
• Climate Mode: Tap the center bar of the lower
section indicator to view the climate mode settings.
There are four climate mode options: Auto, Fan Only,
Heat, and Cool.
Use the tumbler to select your desired mode:
– Choose Auto to allow the system to select the
appropriate operating mode based on the
configured settings and actual temperature
readings.
– Choose Fan Only to turn off the AC or furnace and
use only the fan for the AC unit.
– Choose Heat to turn on the furnace or heat pump.
– Choose Cool to turn on the AC unit.
Refer to the Settings Screen section for
I
information about the Secondary Heat
Management System settings.
When Cool or Auto modes are chosen, a spinning
icon will appear to indicate that the AC unit is
initializing. This can take up to three minutes.
• Fan Level: Tap the right bar of the lower section
indicator to view the fan speed settings for the AC unit.
There are four fan speed options: low, medium, high,
and auto.
Use the tumbler to select your desired fan speed:
– Choose L, M, or H to set the fan to the low, medium,
or high setting.
Dometic Interact
EN