Fitting Instructions - Ermax 7701135 Notice De Montage

1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
The assembly of the Ermax undertray involves the original indicators' removal.
Fitting kit
- 4 silent bloc
- 3 rubber washers Ø6
- 2 rubber inserts M4
- 2 screws BHc 4×15
- 2 fitting brackets (ABS)
- 1 plate lighting N°5

Fitting instructions

- Open the passenger saddle. Remove the grab handles, the rear fairing and the original mud flap.
- As shown on the pictures below, fit both fitting brackets on motorbike and fit the threaded fasteners on the tail
light. Then fit the tail light on the brackets previously placed.
Left side bracket
- Enlarge to a diameter 7,5 mm both side holes of the original undertray and place the rubber inserts (see the
picture).
Rubber inserts location
ON HONDA CBR 500 R & CB 500 F 2013 → ∞
Think to bring blinkers.
- 4 screws BHc 5×20 (small head)
- 3 screws BHc 6×15 (big head)
- 2 plastic washers Ø5
- 2 threaded fasteners M5
- 1 ABS number plate support
- 1 reflector holder SDC02
Threaded fasteners location on
the tail light
FITTING INSTRUCTIONS
ERMAX UNDERTRAY ADAPTABLE
Estimated fitting time 2h
Right side bracket
Silent bloc location on the
undertray