Worx WG512 Mode D'emploi page 12

Removing Clogged Debris from
the Impeller and Blade (Tool Not
Supplied)
Note: 1. Covert the tool from
vacuum mode to blower mode
before cleaning.
2. Remove the plug before opening
the debris cover.
MAINTENANCE
Remove the plug before carrying out any adjustment,
servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If the replacement of the
supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety
hazard.
STORAGE
Store the Blower/Vacuum and extension cord
indoors, in a cool dry location, out of reach of
children and animals.
12
12 AMP 3-in-1 Blow/Vac/Mulch
TROUBLE SHOOTING
See Fig. J1,
J2
Problems
The Blower/
Vacuum
does not
operate.
The Blower/
Vacuum
jammed or
clogged.
The tool
cannot be
converted
from Blower
to Vacuum.
Possible Corrective
Causes Action
The Blower/ Attach the
Vacuum Tube Blower/Vacuum
is not attached Tube to the
to the Motor Motor Housing.
Housing.
Power cord is Connect the
not connected power cord to a
to the power power source.
source.
The leaf Install the
collection bag is leaf collection
not completely bag in place
installed. completely.
The blower/ Push the switch
vacuum to the proper
switch is not position.
in line with the
corresponding
arrow on the
tool.
Debris blocking Remove
in the Impeller clogged debris
from the
Impeller.
Debris blocking Remove
in the Blower/ clogged debris
Vacuum Tube or from the
the connection Blower/Vacuum
of the Leaf Tube or the
Collection Bag connection
of the Leaf
Collection Bag.
Debris blocking Removing
in the Impeller clogged debris
from the
impeller when
the tool is in
blower mode.
EN