Frecan DF HC 60 Manuel D'utilisation page 37

5 Spd Dgt Switch
A ATTENTION
"C" mark will appear at the end of the product's
usage period of 60 hours.
On-Off: The appliance will start once this
button is pressed.
Decreasing Speed: Speed will decrease if
this button is pressed.
Increasing Speed: Speed will increase if
this button is pressed.
Timer: When the button is pushed on, a
timing function is activated for a period of
15 minutes, and once the timing starts,
also the display gives a signal, and the
motor stops automatically after 15 min-
utes.
Lamp: The lamp will turn on once the but-
ton is pressed. Re-press the button to turn
off the lamp.
5
Cleaning Periods of the Filters:
The filters must be cleaned when " " signal ap-
pears on the display or (depending on usage)
after every 2-3 weeks. When the filters are
cleaned and mounted in their places, press but-
ton for more than 3 seconds in order to delete
" " signal (when the product is inactive) .Letter
"E" will appear on the display, and the prod-
uct will switch to normal operation. If the op-
eration is desired to continue without deleting
" " signal, when you push on ( ) button, active
operation will be observed for 1 sec. and then
"C" signal will reappear and the motor will con-
tinue to run.
NOTE: " " mark will appear at the end of the
product's usage period of 60 hours.
Efficient Use With Regard to Energy
Saving:
* When using your hood, adjust the speed set-
tings according to vapour and odour intensity, in
order to save energy.
* Use low speeds (1-2) under normal conditions,
and high speeds (3) in intense odour and vapour.
* The lamps on the hood are placed for illuminat-
ing the cooking area.
Using them for environmental lighting shall
cause unnecessary energy expenditure and in-
sufficient lighting.
Use of Hood:
* Your hood contains a motor that has various
speeds.
17