Life-Threatening Danger, Poisoning Danger; Fire Danger; Danger Of Electric Shock; Danger Of Physical Injury - Frecan DF HC 60 Manuel D'utilisation

2.1 Life-Threatening Danger, Poison-
ing Danger
A DANGER
There are life-threatening danger and poisoning
danger due to reabsorbed combustion gases.
During the air discharge outlet use, unless suffi-
cient air supply is provided, do not use the appli-
ance simultaneously with devices that discharge
toxic gases through flue such as ventilated, gas,
oil, wood or coal burning heaters, shower heat-
ers, water heaters, etc.
Fig. 2: Poisoning Danger
Ventilated devices (e.g. gas, oil, wood or coal
burning heaters, shower heaters, water heat-
ers) take combustion air from the installation
location, and discharge the waste gas through
a waste gas system (e.g. flue). When the cook-
er hood is active, it absorbs air from the kitchen
and neighbouring rooms. If adequate air entry is
not provided
vacuum emerges. In such a case, the toxic gas-
es are absorbed from the flue and waste gas
channel, and are taken into to door again. Fig. 2
Therefore, adequate fresh air ingress must al-
ways be ensured. Fig. 3
Fig. 3
A DANGER

Fire danger!

Due to sparkling. Installation of appliance over
a heating device that is heated by using solid
fuels (for ex. wood or coal) is only allowed if an
non-detachable cover is present. For the instal-
lation process, attention must be paid to current
applicable construction regulations and regula-
tions of local electric and gas companies.
Appliance might lead to fire unless it is produced
in accordance with cleaning instructions.
A DANGER

2.2 Danger of electric shock!

Do not bend or jam the connection cable during
installation due to danger of damaged connec-
tion cable.
A DANGER

2.3 Danger of physical injury!

■ During the installation, there is a danger
of physical injury due to the sharp edges. Use
protective gloves throughout the installation pro-
cess of the appliance.
■ Due to risk of dropping the appliance, as-
sembly of all safety bolts and covers must be
performed as specified in the user manual.
7