How To Replace: Lamp; Troubleshooting - Electrolux KOCEH70X2 Notice D'utilisation

The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.

11.6 How to replace: Lamp

WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
24 ENGLISH
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
The fuse is blown.
Step 3
Put a cloth on the bottom of the cav‐
ity.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
A