Auto S H U T- Off; Cleaning & Maintenance - REVAMP Professional PROGLOSS TOUCH DIGITAL Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
F E AT U RES
1.
Floating ceramic plates
2.
On/off switch & lock/unlock
3.
Digital temperature controls
4. Digital heat display
5.
Touch temperature control + button
6. Touch temperature control - button
7.
Hair Mode button - fine/medium/coarse
8. Non-slip heat-proof silicone mat
TOUC H D I G I TA L H E AT C ON T RO L
Digital variable heat 80 - 235°C enables safer styling for
all hair types and textures. The touch digital heat control
is invisible until switched on. Simply switch on and set
your desired temperature easily. The digital heat display
changes colour based on the temperature you select -
yellow for lower temperatures, orange for mid temperatures
and red for higher temperatures.
PROG LO SS ™ S UP E R S MO OTH OI LS
Every product in the Revamp haircare range is infused with
PROGLOSS™ SUPER SMOOTH OILS - enriched with Argan,
Keratin and Coconut for ultimate smoothness and shine.
INSTR UCT IO N S FO R U SE
Before use, ensure the hair is clean, dry and tangle-free.
For extra protection, apply a heat protection spray.
Section the hair prior to styling. Style the lower layers first.
Plug the product into a 220-240V mains power supply.
Press the on/off button to switch on.
Use the touch temperature control + and - buttons to
select your desired temperature manually or use the
Hair Mode to automatically select the recommended
temperature for your hair type:
SETTING
DISPLAY COLOUR
Fine
Yellow
Medium
Orange
Coarse
Red
The temperature lock will activate automatically after
a few seconds - a lock
symbol will appear on the
temperature display. To switch off the temperature lock
to adjust the heat, press the on/off button once.
We recommend using a lower temperature to start.
Working on one section at a time run the straightener
through the entire length of the hair from roots to ends,
without stopping. Use a comb while straightening for
even straighter results.
Repeat this process all over the head, allowing hair to
cool before combing through.
After using the straighteners, switch off, unplug and
allow to cool before storing away.
Follow us on revamphair.com for the latest hair tips and
advice.
Please note:
Repeat only twice per section to prevent hair damage.
This is a high performance product, avoid frequent use
to prevent hair damage.
EN / 2
1
4
5
180˚
Regular use of styling products may deteriorate the
coating.
Do not scratch the surface of the product as this will
deteriorate the effectiveness of the coating.
While heating, during use and cooling, place on a flat,
smooth, heat-resistant surface. Only hold unit at the
end of the handle.
The product reaches a very high temperature during
operation, please style with caution when using. Make
sure to keep away from the scalp and skin to avoid burns.

AUTO S H U T- OFF

This appliance has an automatic shut off feature for added
safety. If the appliance is switched on for more than 60
minutes continuously, then it will automatically switch off.
If you wish to continue using the appliance after this time,
press the power button to switch on. Use the temperature
control + and - buttons to select your desired temperature.
This feature should not be considered as a substitute for
'OFF' . ALWAYS REMEMBER TO SWITCH THE APPLIANCE OFF
WHEN NOT IN USE.
P LU G (ST-1 500-G B ONLY )
This unit comes with a removable UK 3-pin plug. The 3-pin
plug can be removed to reveal a European 2-pin plug by
unscrewing the centre screw, lifting the rear cover and
unclipping the European 2-pin plug. It can be replaced if
TEMPERATURE
necessary by reversing this procedure.
180°C
200°C
235°C
If required replace plug fuse with one the same value
CLEANI NG & MAI NT ENANCE
Switch the appliance off, unplug from the mains and
allow to cool fully before cleaning.
Wipe over all surfaces using a soft damp cloth. Do not
use harsh abrasives or cleaners.
Do not immerse the appliance in water or and other liquid.
Ensure all parts are dried thoroughly with a soft towel
before reusing.
To prevent cord damage, do not wrap the cord around
the appliance, always store the cord loosely next to the
appliance.
Store in a cool dry place.
3
2
8
6
7

Publicité

Table des Matières
loading

Table des Matières