Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. DISHWASHER CONNECTION PREPARATION
If you are utilizing a dishwasher, complete the following procedure.
Using a blunt instrument (steel punch or wooden dowel), knock out entire plug. Do not use a
screwdriver or sharp instrument. (When knockout plug falls into disposer, you may remove it
or grind it up when the disposer is used. This will not damage the disposer in any way, but it
may take some time to grind).
4. ATTACHING DISCHARGE ELBOW
Depress the wings on the spring clamp to remove it
from the rubber sleeve. Slip the spring clamp over
the smooth side of the elbow and slide it towards the
lipped side of the elbow (see 4A). Insert the waste
elbow into the rubber sleeve so the elbow lip fits into
the groove located inside the rubber sleeve. Position
the spring clamp over the rubber sleeve and secure
(see 4B). If using a straight pipe, use one with a lip
matching the lip on the elbow supplied with the
disposer.
5. LOCKING MOUNTING ASSEMBLY DETAIL
Attach disposer onto the Upper Mount Ring by aligning the three mount tabs on the Lower Mount
Ring with the slide-up Ramps on the Upper Mount Ring and rotating counter clockwise. See Below.
A
B
The lower mounting ring (which is
part of the disposer) has 3 tabs that
grab the mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the
"Ramp".
(C) is the "Ear" that is used to help
rotate the Lower Mount Ring.
Use a screwdriver for leverage if
needed.
6. DISCHARGE ELBOW & DISHWASHER CONNECTIONS
A. Connect bottom of the elbow by tightening
the slip nut (see 6A).
If you are connecting to a dishwasher,
see B. If not, make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
B.
Connect dishwasher hose (6B) using a
hose clamp. Make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
D
C
Lift and turn the Lower
Mount Ring counter clock-
wise until all three mount
tabs lock over the Ridges
(F) on the slide-up Ramps
(D) of the Upper Mount
Ring.
6A
4A
As the Lower Mount Ring is turned counter
clockwise each tab slides up onto the Upper
Mount Ring Ramp (E) and locks in position over
the Ridges (F).
Use a screwdriver or hammer for leverage if
needed.
If a disposer needs to be removed, tapping on
the Ear clockwise with a hammer will easily
loosen the Lower Mount Ring.
DISPOSER
*Air gap may not be required for all
installations. Check local plumbing
codes.
5
WOOD OR
METAL DOWEL
SPRING
CLAMP
RING
F
E
*
AIR GAP
6B
RUBBER
HOSE
DISHWASHER
HOSE
DRAIN
KNOCK
OUT PLUG
4B
Publicité
Table des Matières
