Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To repair faults, switch off the machine. Pull power plug.
Problem
Irregular and discontinuous transport
at the thickness planing
Workpiece shoulder at the planing
Workpiece inaccuracy at the planing
(concave, convex)
Electrotechnical maintenance only by electric specialists!
At waste disposal of the machine all the local legal regulations have to be kept.
16 english
Trouble shooting
Possible Cause
Thickness desk not free of resin or not
free of oil.
This is due to badly adjusted planer
knives.
At not exactly parallel standing
trimming desks due to improper
transport or similar.
Relief
Clean and spray (sliding spray) the
thickness desk regularly. This is valid
especially for wet and resinous woods.
The adjustment of the planer knives
has to be carried out with a lot of care
with help of the adjustment gauge.
Adjust the stiff trimming desk 1 mm
above the planing shaft body, as well
as parallel to the bottom plate.
Publicité
Table des Matières
