Publicité
Les langues disponibles
Les langues disponibles
2
U-
I
NSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, T-wrench
1.
Close choke and remove air filter and cover.
2.
Disconnect ignition stop leads (A) and (B).
3.
Remove inner throttle linkage from carburetor swivel (C).
4.
Loosen the two (2) drive shaft clamp bolts (D) at engine drive
shaft clamp, and remove center drive shaft location bolt (E).
5.
Loosen two (2) rear handle screws (F) and pull rear handle from
the drive shaft assembly.
6.
Loosen two (2) screws (G) and remove front handle.
C
HANDLE
OMBO
K
I
IT
NSTALLATION
I
NSTRUCTIONS
A
B
D
D
E
G
C
F
Publicité
