Connecting Devices And Powering The Ac Unit; Door Locks - Tripp-Lite CSC32AC Manuel Du Propriétaire

4. Setup

4.4 Connecting Devices and Powering the AC Unit

The charging station contains two storage shelves to store and charge your devices. Each storage shelf features 16 strain relief bushings that prevent
the devices' power connectors from slipping through the bushing. To connect a device power connector to the charging station's AC unit, first remove
the blanking panels by inserting your fingers into its left and right holes, and lifting the blanking panel up and pulling out
power plug into one of the AC charger unit's receptacles
a power connection C . Repeat for all devices and reattach the blanking panels.
1
2
A
With the bottom blanking panel removed, find the AC unit's input plug and cable located in the
charging station's bottom compartment, then push the input plug through the one of the cable
access hole grommets located on the either side of the charging station cabinet
cable access hole side as the power cord manager is recommended). Plug the power cord into the
nearest 3-prong, grounded wall outlet and reattach the blanking panel to the unit.

4.5 Door Locks

The split doors contain a lock that is accessible with the included keys.
, then run the power connector through the storage shelf's power cord opening to establish
B
B
D
5
C
(using the same
D
. Connect the device's
A