Setup; Installing The Handle Bracket; Adjusting Storage Shelf Dividers; Powering The Usb Charger/Hub Unit - Tripp-Lite CSC32USB Manuel Du Propriétaire

4. Setup

Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack or mount the charging station without
assistance. Follow the unpacking instructions document that shipped with this product before proceeding with setup. Use
extreme caution when handling the charging station and be sure to follow all handling and installation instructions. Do not
attempt to install equipment without first stabilizing the charging station.
4.1 Installing the Handle Bracket and Power Cord Manager
To install the handle bracket, use the included hex key tool to attach four (4) hex screws to the charging station cabinet
manager, use the same hex key tool to secure the eight hex screws that attach the cord manager brackets (four per bracket) to the charging station
cabinet .
B
A

4.2 Adjusting Storage Shelf Dividers

Your charging station comes with two storage shelves with adjustable dividers that can
each accommodate up to 16 personal electronic devices per shelf.
Remove any personal electronic devices stored on the shelf tray. Then remove the
blanking panel. To remove the shelf tray from the cabinet, push the shelf tray forward
to disengage from the mounting hook, then pull the tray up and out. Once the shelf is
removed, remove or rearrange the dividers by pushing in the two tabs securing the
divider to the rear end A , then push the divider forward to disengage from the shelf
tray . Repeat as necessary for additional shelf dividers.
B

4.3 Powering the USB Charger/Hub Unit

With the bottom blanking panel removed, find the USB Charger/Hub unit's input plug and cable
located in the charging station's bottom compartment, then push the input plug through one of the
cable access hole grommets located on either side of the charging station cabinet
cable access hole on the same side as the power cord manager is recommended). Plug the power
cord into the nearest 3-prong, grounded wall outlet and reattach the blanking panel to the unit.

4.4 Door Locks

The split doors contain a lock that is accessible with the included keys.
B
B
(using the
A
A
4
. To install the cord
A
A