Important Safety Instructions; Overview - Tripp-Lite CSC32USB Manuel Du Propriétaire

1. Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation of the product described in this manual.
Failure to comply may invalidate the warranty and cause property damage or personal injury.
USB Charger/Hub Unit:
• To remove the USB Charger/Hub from the supply mains, the power cord serves as a disconnect device.
• If any of the following situations arise, schedule an appointment with a service technician to have your equipment inspected:
• The equipment has been exposed to moisture
• The equipment has been dropped and damaged
• The equipment shows obvious signs of breakage
• The equipment is not functioning properly or is not functioning according to the instructions described in this Owner's Manual
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support
equipment or to significantly affect its safety or effectiveness is not recommended.
Charging Station Cabinet:
• Keep the charging station in a controlled indoor environment away from moisture, temperature extremes, flammable liquids and gasses, conductive
contaminants, dust and direct sunlight.
• Leave adequate space around the charging station for proper ventilation. Do not block, cover or insert objects into the charging station's external
ventilation openings.
• The charging station is extremely heavy. Use caution when handling the charging station. Do not attempt to unpack or mount it unassisted. Use a
mechanical device such as a forklift or pallet jack to move the charging station in the shipping container.
• Do not place containers of liquid or stack items on the cabinet.
• Inspect the shipping container and the charging station for shipping damage. Do not use the charging station if it is damaged.
• Use caution when cutting packing materials. The charging station could be scratched, causing damage not covered by the warranty.
• Save all packing materials for later use. Repacking and shipping the charging station cabinet or equipment without the original packing materials
may cause product damage that will void the warranty.
For Mobile Applications:
• The charging station comes with four pre-installed locking/swivel casters.
• Always use the included handle when moving the charging station (see section 4.1 Installing the Handle Bracket and Power Cord Manager for
more information).
• When moving the charging station cabinet, always push it from behind; never pull it toward you.
• A rolling charging station can cause personal injury and property damage if not properly supervised. If rolling the charging station down a ramp is
required, use extreme caution. Do not attempt to use ramps that have a slope grade greater than 12%.
For Wall-Mount Installations:
• Casters ship pre-installed with the charging station. Remove the casters and handle before attempting to mount the charging station to a wall (see
section 6.1 Removing Casters and Handle for more information).
• Before mounting, first make sure that the wall surface can safely support the combined load of the charging station, equipment stored and all
attached hardware and components.
• Always use suitable mounting means when installing to cinder block, concrete, drywall or wood studs.

2. Overview

Your charging station is an all-in-one solution for storing and charging for up to 32 devices. With four pre-installed locking/swivel casters and an
attachable, reversible handle accessory, your charging station is ideal for mobile applications. Your charging station can also be conveniently mounted
to walls, as well as configured for stationary desktop or floor placement. To prevent theft and device tampering, your charging station enclosure comes
equipped with locking steel doors.
2