Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Power-On
1)
Pry the switch door open from the bottom using a small
screwdriver.
Ensure the ON/OFF selector is set to ON.
2)
Reset the switch using a paper clip. 0:00 will flash.
3)
If the display is blank:
• Ensure the ON/OFF selector is properly engaged in the ON
position. Push it to the right using a small screwdriver.
• At first power-up after the installation, the screen of the switch
may be blank or dim, or become so when you turn the light on.
However, during that time, the switch is fully functional. Wait 2 minutes for the switch's
built-in battery to be sufficiently charged and the screen will return to its normal contrast.
Selecting the Operating Mode
The programmable switch has 2 operating modes: manual (MAN) and automatic (AUTO).
To change mode, press the switch door for 3 seconds.
Manual Mode
The programmable switch operates as a regular switch. Briefly press the
switch door to turn the lights On or Off. The mode (MAN) and state (ON
or OFF) are displayed.
Automatic Mode
The programmable switch follows the programmed schedule. The mode
(AUTO), state (ON or OFF) and current program number are displayed.
To temporarily override (bypass) the programmed schedule, briefly press
the switch door. The new state (ON or OFF) will flash to show that this
state is temporary. The override remains in effect until you press the
switch door again or until the beginning of the next program.
Setting the Clock
NOTE: The switch displays the time in 24-hour format by default or following a reset.
1)
To change to 12-hour format (or vice versa), proceed as follows:
• Press one of the control buttons to display the MAN or AUTO.
• Press the MIN and HOUR buttons simultaneously and brieftly (0:00 display = 24-
hour, 12:00 display = 12-hour ).
Set the time using the HOUR and MIN buttons. If you have selected the 12-hour format,
2)
ensure that PM appears on the screen when an afternoon time is displayed.
3)
Press one of the control buttons or close the switch door to return to normal operation.
Daylight Savings Time
To set the switch to daylight saving time (Ad) or standard time (nor):
Press the CODE button four times.
1)
Press the MIN button to switch between nor (normal time) and Ad (daylight savings).
2)
3)
Press one of the control buttons or close the switch door to return to normal operation.
2/6
Reset
Control (4)
On/Off
selector
Publicité
Table des Matières
