Using Reefwave Without Reefbeat - Red Sea Reefwave Manuel D'utilisation

Flow Intensity Dial
To change the flow intensity for a Controller Mode wave, press and hold
the center of the dial until the intensity indication LEDs start to blink.
Rotate the dial to the desired direction and intensity as indicated by the
number of blinking LEDs. Press and hold the center of the dial until the
LEDs stop blinking to save the setting. If the desired intensity is not saved
by pressing the center of the dial, after 10 seconds the current intensity
will automatically be selected.
For the Alternating wave, press the center of the dial until the intensity
indication LEDs start to blink. Rotate the dial to the desired forward
intensity, press the center of the dial and rotate to the desired reverse
intensity, press the center of the dial again to return to the forward
direction and save the settings by pressing the center of the dial until the
LEDs stop blinking.
Using ReefWave without ReefBeat - Controller Mode
To operate the ReefWave directly from the ReefWave controller select the
desired wave type using the Wave Mode button and set the intensity and
forward/reverse direction of flow that suits your reefscape. The chosen
wave and intensity will run continuously. You can adjust the flow path
of the pump by rotating the impellor cages. Each cage can be set at a
different angle.
Use the Pause/Play button as described above to stop the pump for
feeding or maintenance.
Connection and initial setup with ReefBeat
In the event that you do not have an available Wi-Fi network you will not
be able to connect the ReefWave unit to the ReefBeat App however you
can operate it via the local controller as described above. At any time, the
ReefWave can be added to an Online ReefBeat aquarium by completing
the onboarding process described below.
If you are already using ReefBeat for a different device (such as
ReefLED) and have your aquarium set to "Offline" you will need to
reset your aquarium to "Online" before you can connect the ReefWave
and implement customized waves and a 24-hour schedule. Once the
ReefWave has been set up you can take your aquarium Offline again
however the ReefBeat shortcuts and Notifications will be disabled and you
will need to take it back online to implement any changes.
Recommendation: Before connecting your ReefWave to the ReefBeat,
start in Controller mode to check out the effect that the ReefWave has in
various locations in your tank. Rotate the cages to learn how it affects the
flow and check out some of the basic waves and learn the strengths of
the various intensity settings.
Red Sea ReefWave ®
ENG
13