CG AIR SILVER Serie Instructions D'installation Et D'utilisation page 4

SLAS · SLAST · SL3 · SLS · MAS · MAST · M3 · MS · PAS · PAST · P3
FUNCTIONS SLAS · MAS · PAS
Your blower is equipped with a built-in ON/OFF air switch
1 press air push:
The blower starts at maximum speed.
st
2 press air push:
The blower stops.
nd
FUNCTIONS SLAST · MAST · PAST
Your blower is equipped with a built-in electronic control, 1 speed
and a 20 minute automatic timer as well as an automatic drying cycle.
1 press air push:
The blower starts at maximum speed.
st
2 press air push:
The blower stops.
nd
Standard function:
A drying cycle will automatically start
the blower for 1 minute, 20 minutes
after the system, stops.
FUNCTIONS SL3 · M3 · P3
Your blower is equipped with a built-in electronic control,
3 speeds: maximum, medium, minimum and a 20 minute automatic
timer as well as an automatic drying cycle.
1 press air push:
The blower starts at maximum speed.
st
2 press air push:
The blower turns to medium speed.
nd
3 press air push:
The blower turns to minimum speed.
th
4 press air push:
The blower stops.
th
Standard function:
A drying cycle will automatically start
the blower for 1 minute, 20 minutes
after the system, stops.
Optional function with SL3 · M3 · P3:
If your blower has been factory set for a 24 hour drying cycle,
program as follows:
1. Determine the time that you wish your drying cycle to start
each day.
2. Completely shut down the electrical current to the blower
for 10 seconds.
3. Start your system for a few seconds.
Your drying cycle will start every 24 hours from that moment on.
In case of a power failure, reprogram as needed.
FUNCTIONS SLS · MS
Your blower is equipped with an integrated air heating element,
built-in electronic control, variable speed, pulsation cycle, a
20 minute automatic timer and an automatic drying cycle.
Optional: water level detectors
1 press:
The blower starts at maximum speed, LED: ON
st
1
2 press:
The blower stops, LED: OFF
nd
1 press:
Speed goes up, LED: ON when pressing.
st
2
Release pressure at the desired speed.
1 press:
Speed goes down, LED: ON when pressing.
st
3
Release pressure at the desired speed.
1 press:
Speed will vary gradually from maximum to
st
minimum and back to minimum, LED: ON
4
2 press:
System turns off and on, then off again, LED: flashes
nd
3 press:
Returns to maximum speed, LED: OFF
th
Standard function:
A drying cycle will automatically start
the blower for 1 minute, 20 minutes after the system, stops.
AIR BLOWERS
5