Ricoh D3210 Mode D'emploi page 14

1. Safety Information for this Machine
• When performing maintenance on the machine, disconnect the power cord from the wall outlet
for safety.
• When moving the machine, be sure to turn off the power and unplug the power cord from the
wall outlet, and then confirm that line cords and other connecting cables have been removed.
Otherwise, the power cord is damaged, possibly resulting in fire or electric shock.
• Avoid the following actions after assembling the stand or mounting the machine on the stand:
These actions may deform or damage the stand, causing it to fall down or causing the machine
to fall off the stand, resulting in injury.
• Placing your weight on the stand
• Hanging on the stand
• Leaning against the stand
• Dragging the stand forcibly
• After mounting this machine on the desktop stand, place the stand at a considerable distance
from the edge of the desk or table. Although the desktop stand has a slip resistant base, such
effect might not be sufficient depending on the location. If you continue to use the stand in such
a situation, the machine may fall off the stand or become damaged, resulting in injury.
• To move this product after mounting the machine on the stand, two or more people are
necessary. Otherwise, the product may tip over or the machine may fall off the stand, resulting
in injury while the product is being handled.
• Do not hang or drape power cords or cables over the stand or this machine after mounting this
machine on the stand. Otherwise, the product may tip over if it is caught in cables, resulting in
malfunction, fire hazard, electric shock, or injury.
• After mounting this machine on the desktop stand, place the product on a desk or table with a
load capacity of at least 50 kg (110.2 lb.). If the load capacity is insufficient, the desk or table
might be damaged, causing the product to tip over or become damaged and resulting in
injury.
• Do not place the product outdoors, or in a position which will allow water onto the product.
Failure to follow this instruction may lead to rust on the metal parts or deterioration in the
moving parts.
10