Remote Control - Xaralyn ALBANY ECO ABN15 E Mode D'emploi

Getting the Desired Flame Effect
1. Using the remote control press MENU, FIRE on the display will be flashing, press ENTER. The current setting
will be displayed. Press ^ or v to toggle between F1 and F6. F1 being the lowest setting and F6 being the highest
setting.
2. Generally the flames appear more realistic when the flame control is turned down.
3. Give the flame generator time to react to changes you may make.
4. The fire will use less water if the flame effect is set to a lower level.
5. Do not tilt or move the fire while there is water in the tank or sump.
6. Make sure that the fire is on a level floor.
Customising the display
The maximum temperature set point on the product is 32ºC You have the option to reduce this set point. You can also
change ºC to ºF
1. Press the Menu button.
2. Press the ADV button twice - SP will be blinking.
3. Press Enter to confirm.
4. Press v or ^ to choose between ºC and ºF.
5. Press Enter to confirm.
6. Press v or ^ to choose your maximum temperature set point.
7. Press Enter to confirm.
8. Press BACK three times to return to the home screen.
Adaptive Start
The built-in electronics in this appliance hava a learning function with regards to how long it takes to heat up a room.
Having learnt how quickly it can heat up your room, the appliance is able to turn on at just the right time in order to get
the room up to a comfortable temperature when you want it. For example, if you get up at 7am, you would normally have
to guess when to turn the heating on in order for it to pre-heat the room in time. Depending on how cold it is outside, this
could mean the room is still cold when you have to get out of bed, or mean that its been warm for half an hour before
it needed to be. Adaptive Start means that if you select 21ºC at 7am, the heater will turn on exactly when it needs to in
order to meet this target, running for shorter periods of time when the weather is mild, and ensuring the room is nice and
warm in the winter.
The Adaptive Start function will automatically activate when you use the Timer Mode.

Remote Control

Display Screen
1
'Menu' Button
2
'Back' Button
3
'Advance' Button
4
'Up and Down' Arrows
5
'Enter' Button
6
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE
Changing lamps.
If a large amount of the smoke appears grey or colourless it may be that one or more lamps have failed.
You can check for lamp failure as follows.
1
2
3
6
35
4
5