Maintenance; Changing The Battery; Cleaning The Casing; Metrological Checks - Würth FMM 10 Notice De Fonctionnement

Only use specified spare parts for maintenance purposes. The
manufacturer cannot accept any responsibility for accidents occurring
following repairs carried out outside its after-sales department or approved
maintenance network.

6.1 Changing the battery

The battery must be replaced as soon as the "low batt" LED lights up
■
Remove the yellow protective casing without removing the prod
■
protection cover (the instrument remains switched off).
Unscrew, then remove by pushing the battery lid backwards
■
Replace the old battery with a 9V battery (6LR61 or 6LF22 type)
■

6.2 Cleaning the casing

Clean the unit with a cloth and a little soapy water. Clean off with a damp
cloth.
Do not use solvents.

6.3 Metrological Checks

It is essential that all measuring instruments are regularly calibrated.
For checking and calibration of your instrument, please contact our
accredited laboratories (list on request) or the Chauvin-Arnoux subsidiary
or Agent in your country.
6.4 Repair
For all repairs under guarantee or outside guarantee, please return the
device to your distributor.
Art. 0715 53 188
Supplied with a grey shockproof cover, a 9V battery and these operating
instructions.
Spare parts :
Test Probe ................................................................... 0715 53 189

6. MAINTENANCE

7. TO ORDER

13