Connecting The Gas Cylinder - Kamino BBQ 131971 Mode D'emploi

EN Safety instructions

Connecting the gas cylinder

• The device may be operated with 5 - 15kg gas cylinders .
The gas cylinder should have a max. diameter of 31.5 cm and
be no taller than 58 cm .
• Always place the gas cylinder next to the device! Never place
the gas cylinder behind the doors of the device!
• The gas barbecue must only be operated with butane or
propane gas and a 50 mbar control (pressure regulator) on a
flexible gas pipe. Please observe the instructions provided by
the manufacturer / supplier of both the gas cylinder and the
control!
• The gas pipe must be no longer than max. 1.5 m.
• Never connect the gas cylinder near sources of ignition! The
same applies when replacing gas cylinders .
Leakage check
Regular leakage checks must be performed whenever connecting
a new gas cylinder and before initial use to ensure that the connec-
tions are secure and no gas is escaping .
• The gas supply must be shut off and all controls placed in the
OFF-position.
• Make a soap solution from water and liquid soap (80% w ater /
20% liquid soap) .
• Dampen the connections and the controls with the soap
solution .
• Turn on the gas flow and turn the control to ON.
• The formation of soap bubbles at the connection points
i ndicates the presence of a leak. DO NOT USE THE GAS
BARBECUE IF THIS OCCURS!
• If no bubbles form then all of the connections are secure and
you may use the gas barbecue. Stop the gas flow and clean
the connection points to remove all traces of the soap solution .
32
131971_Kaminoflam_BBQ_Anleitung_DINA5_DE_EN_FR_IT_ES_132S.indd 32 18.12.19 10:02