Maintenance And Storage - BWT ladybot 200 Mode D'emploi

Maintenance and Storage

Cleaning the filters
The two filters must be cleaned after each cleaning cycle. Press the
buton to release the filter and pull it out of the cleaner. Open the filter
case. Spray water on the outer sides of the filter and then spray water
towards the inner side of the filter to clean all the dirt and debris.
Reinsert the filter back into its location.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in
use: Disconnect the power cord from the wall outlet. Disconnect the
floating cable from the power supply. Make sure that the power supply
is not exposed to water Spread out the floating cable, and roll it. Wash
the cleaner unit interior space with fresh water and let it dry. Roll the
floating cable and place it on the cleaner unit. Caution: Do not roll the
floating cable on the handle of the cleaner unit. Store the robotic cleaner
components in a dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the
propeller of the water outlet: Remove the filters. Remove the screws
that hold the water outlet cover. Remove the water outlet cover. Clean
any hairs, dirt, or debris. Return the cover and fasten it with the screw.
Reinsert the filters.
5
L100 / L200 ROBOTIC POOL CLEANERS