LG DLEX3370 Serie Mode D'emploi page 45

Before Calling For Service (cont.)
Problem
Steam does not • Water level error.
generate but
no error code is
shown
Garments still • Too many or too different types
wrinkled after
of garments in dryer.
STEAM FRESH™
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
STEAM FRESH™
Garments have • This is normal.
static after
REDUCE STATIC
Garments are • Correct drying options not
too damp or selected.
too dry after
REDUCE STATIC
Garments are • Number of garments or load
not uniformly size not properly selected at the
beginning of the cycle.
damp after
EASY IRON
Water drips • This is normal.
from door
during Steam
Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not
• This is normal.
turn during
Steam Cycle
Cannot see • This is normal.
steam vapor at
the beginning
of cycle
MFL67731035_en_140818.indd 45
Possible Causes
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting REDUCE
• Select the correct number or garments or load size before
• Condensation will normally form on the inside of the
• Steam vapor is difficult to see when the door is closed.
• The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
• Steam is released at different stages of the cycle for each
TrOuBLEShOOTiNg
Solutions
STATIC option.
starting the cycle.
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
option.
45
2014.8.18 9:37:38 AM