Functions And Controls - Rohr DFC-10P Mode D'emploi

DFC-10P / DFC-50P / DFC-450P / DFC-650P English

Functions and Controls

Voltage Selection
For models with a switch - change the switch to alter the voltage.
For models with terminals - the negative wire is hard wired, swap the positive wire to the desired voltage
position.
Amperage Selection
For models with a dial - turn the dial to increase the Amp output. Higher numbers produce a higher
Amperage. For models with a switch - change the switch to alter the amperage. MIN - trickle charge /
MAX - fast charge
Pulse Repair Technology
Older batteries can lose their ability to hold charge due to becoming sulphated. This charger features
highly advanced pulse rectifier boost battery repair technology that actively repairs this damage. This
battery restoration feature can get almost any battery back to full health.
Mode Icons
For models with both charge and jump start functions - there are two symbols to indicate the function
type:
+ - + -
Charging mode Jump Start Mode
© ROHR
4