Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Category
20V Hub/HubX
Only use the appropriate accessories intended for this tool. Accessory information
can be found on the product packaging, at a Worx dealer or on our website at www.
worx.com.
MakerX series tools and 20V Hub/HubX are specially designed to work together, so
do not attempt to use any other devices.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The tool can be used for bonding wood, leather, plastics ,papers and other mate-
rials.
EN
8
ASSEMBLY
1. Insert the appropriate glue stick for the material being glued via the hole at
the rear of the glue gun.Use 0.28'' (7mm) mini glue sticks (See Fig. A)
2. Connect the gun and the hub. (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the "Min" position. (See Fig. C) and the surfaces to be glued
must be clean, dry and free of grease.
NOTE :The speed control does not work with the glue gun. The speed control
is for other tools, such as the MakerX Rotary Tool or Angle Grinder.
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip. Press
the on/off switch on the hub. Then press button on the tool for 3s until the it turns
red ,which means the glue gun is heating. When the light turns green, the gun is
ready for operation. Press the trigger for gluing. (See Fig. D,E,F) After applying the
glue, immediately press the surfaces to be glued together.
It is recommended to apply the glue on large surfaces or long work
NOTE:
pieces in the form of points. On flexible materials, apply in lines.
WARNING: Do not allow the hot glue or the nozzle tip to come into contact
with persons or animals.If hot glue contacts with the skin, do not try to
remove the glue from the skin,but put the affected area immediately under a
stream of cold water for several minutes.
Model
WA7150
WA7151
Output 2: 5 V
Capacity
Input: 20 V
10 A Max.
Output: 20 V
10 A Max.
Input: 20 V
10 A Max.
Output 1: 20 V
10 A Max.
2 A (USB port)
Publicité
Table des Matières
