Worx MAKERX WX746L Mode D'emploi page 10

Glue does not flow
evenly.
Adhesive surface only
bonds on one side.
Adhesive bond doesn't
work after cooling.
Glued tiles in moist
locations are not
adhesive.
EN
Glued shoe soles are
10
not adhesive.
Strands are pulled
out when removing
the glue gun from the
work-piece.
Work-piece melts.
Glue stick's melting
temperature is too low.
Glue is not heated long
enough.
Trigger is not pressed
uniformly.
Adhesive already partially
has cooled off before
work-pieces have been
bonded.
Surface is greasy or too
smooth.
Surface is dusty.
Unsuitable material or
work-piece.
Moisture spreads under
bonding parts.
Moisture causes leather to
puff up and creeps under
bonding location.
Trigger is still pressed after
operation.
Nozzle has not been wiped
off.
Work-piece contains
material that melts at a low
temperature.
Wait for heating.
Allow the glue gun time
to heat up.
Press trigger slowly and
uniformly.
Bond work-pieces in a
quicker way.
Set gluing points instead
of applying glue over
surface.
Roughen adhesive
surface slightly.
Clean the surface.
Use specialized
adhesive.
Suggest to use
specialized adhensive
suitable for moist
locations
Use specialized
adhesive.
Discontinue pressing
trigger before
completing the
operation.
Wipe off nozzle.
Use specialized
adhesive.